Set The Integrated Management Controller Ip Address - Cisco C880 M4 Configuration Manual
With sap hana tailored datacenter integration
Hide thumbs
Also See for C880 M4:
- Service manual (132 pages) ,
- Operating manual (58 pages) ,
- Service supplement manual (27 pages)
Table of Contents
Advertisement
Table 1.
Item
Baud rate
Data bit
Parity bit
Stop bit
Flow control
Emulation
Note:
After the serial connection is opened, you will see an initial message and login prompt on the terminal software
screen. Enter the login name as Administrator. This is the preset default administrator user account name. After
entering this user name, you are asked to change your password immediately.
3.
Cisco-1541432026 login: Administrator
You are required to change the password immediately (root enforced)
New password:
Retype New password:
Administrator >
Note:
Set the Integrated Management Controller IP Address
Now set the IMC IP address.
1.
2.
Administrator> set
Administrator> set gateway <ip address>
Administrator> set http enable
Administrator> set telnet enable
3.
Administrator> set
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Cisco IMC Connection Settings
Value
19200
8
None
1
None
VT100
The MMB initialization process takes about 6 minutes to complete.
Enter a new password. Then reenter the same password.
To see more commands and command syntax, enter the help command.
Verify that the IMC ports are connected to the management network as shown in Figure 7.
After resetting the password as in the previous section, enter the commands shown here to set the IMC IP
address and enable HTTP and Telnet access to it.
ip <ip address> <netmask>
The default HTTP port is 8081. You can change this port if required by entering the following command:
http_port 80
Page 14 of 146
Advertisement
Table of Contents
