By placing a Netgear router after Vilfo, your Netgear router can be used to extend the wireless network of Vilfo.
Turning your Netgear router into an access point
Log in to your Netgear router. This can usually be done by going to http://www.routerlogin.com/ and entering the username and password for your Netgear router. Username and password can often be found on a sticker under your router. Unless you have changed it manually, the username and password is normally admin and password by default
Navigate to ADVANCED β Advanced Setup β Wireless Settings
Check the box Enable AP Mode
Verify that Get IP Address Dynamically and Get DNS Server Address Dynamically are both checked
Click Apply
Connect a network cable between LAN port on your Vilfo and the WAN port on your Netgear router
To make future changes in your Netgear router you will need to do so using the IP address assigned to your Netgear router by Vilfo.
β
βNote! If you choose to use your Netgear router as an access point, you may want to disable the Wireless network in Vilfo.